Welcome to CuVoodoo,
the sorcery of copper.
splice = splite | slice
an IP67 silicon tube
and soldermask
this white marking lines indicate where to cut
30 fps
outgoing, not outcoming
nano-seconds, not micro-seconds
1.25 micro-seconds, not 1.28
+/- 300 nano-seconds
again, 1.25 us. seriously, don't listen to the values I say
20 cycles
+/- 600 ns per bit, that's ~ 9 cycles
using precomputed output values
the bytes contains the bit values to be sent on the port for this pin (as done with the mask)
actually this OR with low is not required as the assembly code will always do it
the pin will be set (kept) high if it's a 1
actually the oscilloscope is not dispaying the values I wanted, but the timing is correct in the end
D2 to D8
60 x 60 mA = 3.6 A (not 3.4)
1.78
actually I already explained it just before
you general use 4 LED strips, 1 per side
0xff = broadcast
except the sync, which is a pain
sorry for the blur, the scene is too white uniform for the camera to focus
what is even "better"